|
Products - Bathroom - Kitchen
- Wall Cabinet Lift 503
| General: The type 503 lift is mainly intended for adapting the dwelling to the needs of the disabled, while retaining parts of the existing kitchen. However, the lift can also be used together with the variable-height worktop unit 502 for total conversion of the kitchen. | ||
| Design: An actuator lowers the cabinet frame in a curved path down towards the worktop below the cabinet. The frame is secured to a wall frame by means of four pivot arms. The wall cabinets are secured to the steel frame and are moved forward and downwards to the front edge of the worktop. | ||
| Safety: A trip panel with reversing function is fitted under the cabinets. | ||
| Materials: Steel profile frame, actuator and control unit, spiral cables, control unit with cable, chipboard trip panel. | ||
| Colors: Steel profiles painted white, pale gray and metal actuator, pale gray control unit, white terminal boxes, whilte trip panel. | ||
| Loading: Max. loads: 100kg for 57cm wide unit, 150kg for 97cm wide unit, 200kg for 137cm wide unit. | ||
| Travel: 45cm up/down. Speed: 1.7cm/s | ||
| Dimensions: 69cm high frame intended for 70cm or higher cabinets. The lifts are available in three widths - 57, 97 and 137cm. Choose the lift to suit the number of cabinets to be mounted. See table. |
|
 |
| Connections: Connect the motor to the 230V supply, rated for a maximum of 1A. Locate the wall socket above the lift. If lighting is included, one socket is needed for every light fitting. The lighting is of low voltage type (240). Connect a plug-in type transformer to the socket and run a spiral cable from the transformer to the light fitting. | ||
| Control: Standard: Push-buttons with 5m cable. Option 1: Manual control with spiral cable. Option 2: Remote control. | ||
| Installation: Secure the wall frame firmly to the wall by means of screws and then make the electrical connections (all connections of the plug-in type. Mount the cabinets, secure them in position with screws and screw them together. Fit the trip panel. Connect to the electrical control. Check the travel and operation of the trip panels. The cabinet lift should be mounted so that there is a gap of about 0.5cm in relation to the adjacent cabinets. | ||
| All electrical components are CE marked. | ||
| Miscellaneous: No extractor fan can be fitted to the wall cabinet lift. The Extractor fan must be stationary and must be mounted 50cm above the stove. The spout of an ordinary sink mixer tap must be turned sideways before the lift is lowered. | ||
 |
Barrier Free Architecturals Inc.
US: PMB 289, 908 Niagara Falls Blvd., North Tonawanda,
N.Y. 14120-2060
Canada: #24 - 2700 Dufferin Street Toronto,
Ontario M6B 4J3
TEL: 416 783 5331 • FAX: 416 783
6505
